Switching between modules via program change

Post here if you are having problems with audio or MIDI hardware within forte

Moderator: MikeG

patience1312

Switching between modules via program change

Postby patience1312 » Wed May 02, 2012 9:01 am

Hello!

I tried to figure this out by searching through the forum, but I can't find a solution for this:

My setup is as following:

-------------------------------------------------
Akai Miniak
Boss FC-50 - sending program changes
Forte - Demo mode
------------------------------------------------

How can I switch through my modules (Absynth, Omnisphere or Battery) by sending program changes via my Midi-Foot-Controller?
I tried to up the following in the Control Surface Definition Editor:

Module 1 Mute Toggle from Midi Controller event, on channel1, any CC#, Value=1(2,3,4)

Is this the wrong way or did I forget something?

Thanks in advance,
Eric

Dirk Offringa
Posts: 3508
Joined: Sat Mar 06, 2004 3:44 am
Location: Sainte Anastasie, France
Contact:

Re: Switching between modules via program change

Postby Dirk Offringa » Wed May 02, 2012 9:47 am

Hi Eric,

Program changes are not CC's! You must send CC's to switch the mute status using the CS interface. If you can't send CC's, then you can make scenes for each enabled instrument then change scenes with PC's.

Dirk
Life would be much easier if I had the source code.


Return to “Audio/MIDI Hardware Issues”

Who is online

Users browsing this forum: No registered users and 2 guests