DELTA 1010

Post here if you are having problems with audio or MIDI hardware within forte

Moderator: MikeG

Austin73

DELTA 1010

Postby Austin73 » Mon Feb 09, 2009 8:28 am

Wondered if anybody could help. Trialing Forte at the moment with a Delta 1010 Having lots of problems though. The card usually give me lots of low latency fun using all sorts of software from Waves GTR to Cubase and Ableton.

When I load Forte I get nice clear audio for about 30 seconds then the fizz starts which leads to bit crunching then hardly any sound at all.I do try and and change the sample rate etc to no avail.

Anybody got any ideas as I don't want to commit if it isn't going to work.

Cheers

MikeG
Posts: 3936
Joined: Tue Nov 19, 2002 11:56 am
Location: Houston, TX, USA
Contact:

Re: DELTA 1010

Postby MikeG » Mon Feb 09, 2009 8:52 am

I know there are lots of people here using it. Please look at the Operations Guide troubleshooting section. There may be a tweak you need to set up.

Are you using ASIO mode or WDM?
----------------
Mike (brainspawn)
www.brainspawn.com/support

PLEASE NOTE that the forum is not monitored as frequently as the support site above. This forum is intended primarily as a way for users to ask other users questions about the use of Forte.

Austin73

Re: DELTA 1010

Postby Austin73 » Tue Feb 10, 2009 5:02 am

Feel really silly but got it working fine now - looks like I caught the gain switch on the back of the unit! Turned it off 4db and now up and running perfect - I think freeamp 3 wasn't helping either !

Cheers for the input

Was using ASIO and WMD which both work fine now.

Its a very good piece of software and now I have finally found something to put my Parker Fly thru - only trouble is its not my kit so I have to give it back :(

Aus


Return to “Audio/MIDI Hardware Issues”

Who is online

Users browsing this forum: No registered users and 1 guest