Audio Input and Mix

<< Click to Display Table of Contents >>

Navigation:  Using Plugins >

Audio Input and Mix

Previous pageReturn to chapter overviewNext page

Audio inputs enables you to run audio from external sources through modules and buses. Audio inputs are available on any instrument module in the Audio Mix tab of the console.





You may select the mono or stereo audio input source and monitor the input levels. Select “No Audio Input” from the input selection box to turn off audio input.


Although some instruments will process audio input, most will not. For this reason there is a special module you can create from the add module menus called ‘brainspawn Audio Input’. This module is a module without an instrument. In the Audio Input module, the audio is sent directly from the input to the module’s insert effects.


WARNING! Be very careful when using audio inputs that you do not accidentally enable an audio feedback loop! This may damage your audio equipment if volume is too high.